These rabbits have been sent to destroy Sarah Conner

20080117_pid39099_aid39094_contact2_w600.jpg

Researchers at the University of Washington managed to embed an electronic circuit and LEDs directly into contact lenses, which seemed to look good on rabbit eyes. Though the circuit is not functional and the lights don’t light up, the development shows that future applications like direct video to the eye may indeed be possible.

The prototype device contains an electric circuit as well as red light-emitting diodes for a display, though it does not yet light up. The lenses were tested on rabbits for up to 20 minutes and the animals showed no adverse effects.

Ideally, installing or removing the bionic eye would be as easy as popping a contact lens in or out, and once installed the wearer would barely know the gadget was there, Parviz said. [Babak Parviz is a University of Washington assistant professor of electrical engineering –ed.]

Building the lenses was a challenge because materials that are safe for use in the body, such as the flexible organic materials used in contact lenses, are delicate. Manufacturing electrical circuits, however, involves inorganic materials, scorching temperatures and toxic chemicals. Researchers built the circuits from layers of metal only a few nanometers thick, about one thousandth the width of a human hair, and constructed light-emitting diodes one third of a millimeter across. They then sprinkled the grayish powder of electrical components onto a sheet of flexible plastic. The shape of each tiny component dictates which piece it can attach to, a microfabrication technique known as self-assembly. Capillary forces — the same type of forces that make water move up a plant’s roots, and that cause the edge of a glass of water to curve upward — pull the pieces into position.

The prototype contact lens does not correct the wearer’s vision, but the technique could be used on a corrective lens, Parviz said. And all the gadgetry won’t obstruct a person’s view.

“There is a large area outside of the transparent part of the eye that we can use for placing instrumentation,” Parviz said. Future improvements will add wireless communication to and from the lens. The researchers hope to power the whole system using a combination of radio-frequency power and solar cells placed on the lens, Parviz said.

20080117_pid39104_aid39094_contactlenshand_w600.jpg

[read the complete article via uwnews.washington.edu]

Comments are closed.